Wireless Remote Entry Way Alert Chime System w/ 35 feet Beam

Wireless remote chime (up to 2000" line of sight transmission distance) entry way alert is activated when person or object passes through or across IR invisible beam. Beam sensor is powered by 12vdc adapter (included) on one side and by non-powered reflector on other side of entry way (separation of sensor and reflector can be from 1 foot up to 35 feet). Reflective Beam Entry Way Sensor includes 6" of cable and must be wired to 9V battery powered wall-mountable transmitter and included 12vdc adapter (instructions included). Transmitter settings allow one of four tones/chimes to be sent wirelessly up to 2000 feet (line of sight) away to Audible alert receiver with on/off switch and volume control. Chime selection (Classical, Westminster, Ding Dong, Whistle) only sounds twice when something passes through invisible IR beam. Multiple entry ways can be monitored with additional sensors ( item 80-403 ), power supplies ( item 60-300 ) and transmitters ( item 60-105 ). The additional entry ways can be set to individual unique chime settings if desired. Multiple wireless wall/desk receivers ( item 60-509 ) and or pagers ( item 60-103 ) may be used with single or multiple entry transmitters. Included receiver allows external sounders or accessories to be wired via a 12vdc output (400mA for selectable 4 seconds or 10 minutes) on channel/zone 1 and NO/NC relays (24vdc @ 3amps) for each of 4 channels/zones. Transmitters/receivers can be set to one of 256 frequency settings to avoid interference with nearby retailers using same system.

Optional Extra Loud indoor Siren or Steady Tone Electronic sounder available for high noise areas, see item 60-206.

Accessory power output (for each channel or the 12vdc output) can be increased with an optional 500mA or 1amp 12VDC adapter and/or the output duration time of any of the 4 individual NO/NC channel relays or the 12VDC output can be delayed or extended from 1 second to 60 minutes with the optional Programmable Relay Timer Module - (item 60-440).

Receiver Instructions

Transmitter Instructions

Reflective IR Beam Sensor Instructions

Addendum to Instructions

NOTE: This system is NOT plug"n play installation. Low voltage wiring required (click here for instructions included) and product set-up and mounting required. #ChimeAlert, #EntryAlerts https://www.entryalertproducts.com/product/wireless-remote-entry-way-alert-chime/