Tuesday, November 21, 2017

Recordable Entry Alert / Motion Alarm

MOTION ALARM AND MOTION DETECTION ALARM SYSTEM


Protect your home, valuables and most importantly - your family with the amazing Sound Sentry XL motion alarm. It"s a portable recordable motion alarm that you can place anywhere, your home, your office, your car - anywhere! This inexpensive motion sensing alarm system has hundreds of uses. It"s also great for Halloween or Christmas greetings on your door!! With the included removable sticky pads and velcro strips you can stick it to any flat surface (such as a wall) or use the included stand to place it on the floor or a table. Press the record button to record any sound, from alarm sounds to dogs barking to a verbal warning - anything you can think of! The sound plays when anything moves within 11 feet of the sensor. Runs on regular "AAA" batteries

The Sound Sentry allows you to record any sound, from Barking Dogs to alarm sounds - even gun cocking sounds!. Doorbells, voice memos, practical jokes - just about anything you can think of. Below is the full instruction guide on how you can make the most of of your Sound Sentry XL!

Using the SOUND SENTRY XL
The Sound Sentry XL has an on/off switch located on the top of the unit. Ensure the unit has 3 AAA batteries installed and the on/off switch is set to "on".

1. To record a new sound hold down the REC button located on the front of the Sound Sentry and speak or use your computer to play your sound effect at least 7 inches away from the microphone in a room with little or no background noise.
2. To stop recording, release the REC button.
3. To test your sound effect move your hand in front of the sensor bubble near the bottom of the unit.

The Sound Sentry has a maximum detection range of about 10 feet so place your unit accordingly.

REPLACING THE BATTERIES*

The Sound Sentry XL uses 3 AAA type batteries. Replace the appropriate batteries when the sound volume begins to decrease or playback is distorted.

1. Remove the screws from the battery compartment cover with a Philip screwdriver.
2. Take out the old or weak batteries and replace with new batteries according to polarity symbols marked inside.
3. Replace the cover, then inset and tighten the screws.

Sound Sentry XL Tricks and Tips
You can turn your Sound Sentry XL into anything from a Barking Dog Alarm to a buzzer alarm (use our free sound library here on the site!), leave messages for your family - it can even be a doorbell - just use a doorbell sound and stick it near your door with the included sticker.
Here are some helpful tricks and tips for recording sounds with your Sound Sentry XL!

1. Make certain when you press the record button your finger/thumb is not covering the microphone area.
2. For cleanest recording use the entire 7 seconds.
3. To force a playback delay play your sound and then record silence until the 7 seconds is up, then release the record button. The Sound Sentry will play the sound and your recorded silence becomes a delay before the sound will play again.
4. Note motion that is very close to the sensor (less than 6 inches) is not easily detected as it obscures the entire sensor area. Effective range is 6 inches to about 11 feet away.
5. It is recommended you do not record into the Sound Sentry XL like a Walkie-Talkie. Best results occur when you record clearly from at least 6 inches away from the microphone. http://www.entryalertproducts.com/product/recordable-entry-alert-motion-alarm/

No comments:

Post a Comment